Oct 24, Oct 19, #9.
Re: water inlet tube alpha 1 - the fight continues. Here's a pic of the inside of the transom assembly. (Never mind the wording on the pic). You would remove the two bolts holding the plate on (around the tube). The you can pull out the rubber grommet that holds the tube in treeleaning.buzzted Reading Time: 6 mins. Apr 30, I am trying to get a sense of what's causing this water leak. 23' Glastron Mercruiser Alpha One Outdrive The slow stream of water enters the boat at the bottom and center of the inner transom plate between it and the transom wood.
All my bellows were new in August In July ofI hit a rock, taking the skeg off the bottom of the. May 27, Water pump help Regal: I recently changed my water pump in my Alpha one /gen one outdrive that cools a mercruiser magnum engine. I installed a new impeller, housing and gaskets.
I put everything back together exactly as removed and carefully double checked before reassembling. When I. Apr 29, Re: 85' Alpha - Need to replace outer water supply hose I have the exact same problem. I have an '84 Cobalt DV18 with an '85 MR outdrive and a '95 EFI Bravo engine. The bellows are perfect, but the water hose is cracked to hand leaking like a sieve toward the bell housing side.
The part of the hose toward the gimball housing is OK. Jul 22, You need to remove the u-joint bellows so you can access the top fitting where the hose is connected. Tech Support.PM #3. [email protected] View Profile. View Forum Posts. Private Message. The Alpha One and"R" pumps have a plastic upper housing and the Gen 2 drives have a Stainless housing.
Remove the housing nuts and/or screws and lift the housing off the shaft. Remove the impeller, the key and the wear plate. The Alpha One and the"R" drives have plastic water pump bases. We strongly recommend that you replace the water pump base!